Switch heating method
On convertible washer-disinfectors, the heating method can
be switched, e.g. from electric to steam heating, via the
context menu.
^
Selelct the
Steam/Electric option and activate it with OK.
^
Change the heating method setting to the one you require,
e.g.
Steam+electric and confirm your selection with OK.
The changed heating method is now saved to memory.
^
Press +C to come out of the context menu.
Current faults
The current fault messages can be called up in operator level
D under this menu option.
^ Select the option and confirm your selection with OK.
Any faults which are present at the moment will be displayed.
^ Use OK to change between the fault messages.
^ Press +C to come out of the context menu.
Load items
If a barcode scanner has been connected to the
washer-disinfector and the load scan is activated, scanned
loads can be listed in the context menu under this option.
All of the procedures in connection with the barcode scanner
are described in the section "Barcode scanner".
Context menu
26
To Next Page
Loading...
