Scanning the barcode with a conveyor system connected
If a conveyor system is connected to the washer-disinfector,
in operating level C only loads which have already been
scanned will be reprocessed.
,
The order of the scanned loads in the Profitronic must
correspond with those of the mobile units on the loading
conveyor.
When the message
Process parameters achieved appears
at the end of the programme, the scanned loads which have
been reprocessed will disappear from the display.
If a programme is cancelled or if a fault occurs during a
programme (
Process parameters not achieved), the
scanned load which was last reprocessed will not disappear
from the display. It will be reprocessed again when the
programme is restarted after rectifying the fault.
If you do not wish a scanned load to be reprocessed
again from the beginning, it must be deleted from the
display manually.
Barcode scanner (optional)
52
To Next Page
Loading...
