Cancelling "Scan the load"
Providing a load has not been scanned, scan the load can be
cancelled by pressing the +C button. The programme
overview will appear in the display again.
If loads have already been scanned, these must be deleted
before cancelling. To do this, for each scanned load answer
the question
Delete last entry? with Yes.
Skipping "Scan the load"
In operating levels B and D, Scan the load can be skipped by
pressing the OK button.
If the question
Skip load scan? is answered with No, the
programme overview appears in the display.
If the question is answered with
Yes, the programme can be
started again by pressing the h button.
"Load scan skipped" will be printed at the end of the wash
report.
Closing "Scan the load"
^ After all of the barcodes on a load have been scanned,
close the process by pressing OK.
The h button will flash and the programme can be started.
Accept scanned loads
When "Scan the load" is activated, the Profitronics check
before the programme starts that at least one scanned load
has been saved to memory.
Barcode scanner (optional)
56
To Next Page
Loading...
