Adding and dispensing process chemicals
46
Close the container.
Wipe up any spilled rinsing agent. This prevents over-foaming oc-
curring during the next program.
Refill indicator
When the fill level is low in the (DOS 2) supply container for rinse aid
you are reminded to refill it.
Confirm the message shown with OK and
refill the rinse aid as described.
Dispensing
rinsing agent
The dispensing concentration is set by Miele Service.
- If there are spots of water left on wash items after reprocessing,
then the dispensing concentration is set too low.
- If clouding or smearing appears on wash items after reprocessing,
the dispensing concentration is set too high.
In either case contact Miele Service and have the dispensing con-
centration reset.
To Next Page
Loading...
