Adding and dispensing process chemicals
50
Wipe up any spilled process chemical thoroughly.
Place the container on the floor next to the machine or in an adja-
cent cabinet. The container must not be placed on top of or above
the machine. Make sure that the dispensing hose is not kinked or
trapped.
After that, the dispensing system must be primed (see “Settings /
Priming DOS”).
Checking con-
sumption
Check consumption regularly by checking the fill levels in the supply
containers and replace containers in time.
Refill indicator
When the fill level is low in the DOS 1 supply container for liquid
process chemical, you are reminded to replenish it.
Confirm the message shown with OK and
Refill the liquid process chemicals as described.
If the container is empty, the machine will be locked against further
use.
It will be ready for use again when the supply container has been
replaced.
Dispensing liquid
process chemi-
cals
The dispensing concentration is set by Miele Service.
To Next Page
Loading...
