Technical Information
24
PW 6xx7
Internal structure of program header for a Profitronic M washing
program:
Item number in table Item description Options Details
1 Program no. 1 to 999
Allocation of the program
position number, e.g., 123.
The default number set as
standard at the factory will
be the lowest vacant
number.
2 Program name All available
alphanumeric and
special characters
Allocation of the program
name. Maximum name
length 25 characters, e.g.,
Cottons 40°C.
3 Material number
(Mat. no.)
All numbers
The supervisor/ programmer
only can read this field. If the
supervisor/programmer
creates a new program, this
field is filled with Xs
(“xxxxxxxx”). The production
factory only is able to enter
an 8 mat. no. to identify a
genuine Miele program, e.g.,
“06110050”. Whenever an
original Miele program is
modified, this number is
deleted automatically
(blank field)!
4 ID no.
(identification
number) until ID
846, canceled
from ID 1000
All numbers
The supervisor/ programmer
only can read this field. The
control automatically enters
the software version number
of the control under which
the wash program was
created. If the
supervisor/programmer
modifies the wash program
and saves it, the control
overwrites the previous
software version number
with its own current software
version number.
5 Area 1 No, 1 to 10 blocks
Sets the number of individual
blocks in area 1, e.g., none if
No is set. If the supervisor/
programmer selects at least
one block here, a name for
the area must be entered.
Default factory setting: No.
6 Name area 1 All available
alphanumeric and
special characters
Allocation of the name for
area 1. Default factory
setting: Pre-wash. Maximum
name length 20 characters,
e.g., Pre-wash cold.
7 Area 2 No, 1 to 10 blocks
Fixes the number of
individual blocks in area 2,
e.g., 10 blocks if 10 blocks
is set. If the
supervisor/programmer
selects at least one block
here, a name for the area
must be entered. Default
factory setting: No.
To Next Page
Loading...
Need help?
General
