Technical Information
25
PW 6xx7
Item number in table Item description Options Details
8 Name area 2 All available
alphanumeric and
special characters
Allocation of the name for
area 2. Default factory
setting: Main wash.
Maximum name length 20
characters, e.g., Main wash
90°C.
9 Area 3 No, 1 to 10 blocks
Fixes the number of
individual blocks in area 3,
e.g., 4 blocks if 4 blocks is
set. If the supervisor/
programmer selects at least
one block here, a name for
the area must be entered.
Default factory setting: No.
10 Name area 3 All available
alphanumeric and
special characters
Allocation of the name for
area 3. Default factory
setting: Rinses. Maximum
name length 20 characters,
e.g., Final rinse cold.
11 Weigh No
It is not possible to enter a
weight before the start of the
program. The control
operates with the rated load
for the machine. Default
factory setting: No.
Manual
The operator weighs the dry
laundry then enters the
established weight manually
in the machine before the
start of the program.
Automatic
Using the load module, the
weight of the load can be
entered automatically in the
machine control before the
start of the program.
12 Max. load 0.0 kg, 0.2 kg, 0.4
kg, 0.6 kg, ..., 32
kg; in 0.2 kg steps
The coding plug for setting
the model automatically
limits the possible entry to
suit the model in question.
The rated load entry can be
used as a guide for a
reduced load quantity, e.g.,
3.5 kg for Minimum iron;
see Table 100-7. Default
factory setting: Maximum
value in accordance with
machine model coding plug.
For PW 6107, e.g., 10.0 kg.
13 Min. water level 0 mm, 2 mm, 4
mm, ... 350 mm in
2mm steps
Here the programmer sets
the minimum water level in
the machine in mm wc (mm
water column) for all blocks
without heating. This figure
sets the lowest level that can
be selected and can be set
between 0 mm to 350 mm in
2mm steps. Default factory
setting: 0 mm.
To Next Page
Loading...
Need help?
General
