Technical Information
26
PW 6xx7
Item number in table Item description Options Details
14 Fill type Water height in mm
Fixes which type of
monitoring is used by the
control to register the water
level when filling the
machine. The setting options
available later in the wash
program depend on the type
of fill programmed here.
Default factory setting:
Water height in mm, “mm”
stands for millimeters of
water column (mm wc). If,
after creating a program, the
programmer changes the
type of fill in the associated
program header from Water
height in mm to Water
quantity in L or Laundry:
Suds ratio in kg/L, the
control resets the level
settings in the blocks to 0
mm accordingly. If a change
is made from Water height
in mm to Auto load
adjustment, no
modifications are made in
the blocks. If a setting is
made that is above the
maximum permitted water
level for the machine, the
control automatically limits
this to the permitted
maximum. If a setting is
made that is below the
minimum permitted water
level or the minimum heating
level for the machine, the
control, for safety reasons,
automatically increases this
to the permitted minimum in
case heating occurs during
the program. If the control
acts in this way, it is shown
at the end of the program via
the displays Level limitation
or Level increase.
To Next Page
Loading...
Need help?
General
