Technical Information
30
PW 6xx7
35 program steps. In this way the modification or creation of a wash program
is carried out using the building-block principle.
Parameter modification of programs in the specially protected program
positions 1 to 16 (basic programs) is only possible after the basic program
lock has been suspended.
Block programming - Profitronic M washing control:
No. Program step Basic
setting
Setting options Notes
0 Block name
20 blank
spaces
All available
alphanumeric and
special characters
For naming block 1. Maximum name
length 20 characters, e.g., Pre-wash.
1 Block activation
No No Program block will be skipped before and
during program.
Permanent Program block will always be carried out
during program.
Block + Program block will only be carried out
when Block + button is activated before
the program is started or during the
program before the block would be
started, otherwise block will be skipped.
2 Program stop 1
No No No stop during program.
Permanent Program always stops at this point.
Program is continued by pressing the
Start button.
Starch stop Program stops at this point if the operator
has pressed the Starch stop button
before the program reaches this stage in
the program sequence. Program is
continued by pressing the Start button.
Spin stop Program stops at this point if the operator
has pressed the Spin stop button before
the program reaches this stage in the
program sequence. Program is continued
by pressing the Start button.
Spin stop and starch
stop
Program stops at this point if the operator
has pressed the Starch stop and Spin
stop buttons before the program reaches
this stage in the program sequence.
Program is continued by pressing Start.
3 Program stop
signal 1
No No No stop signal at Program stop signal
output.
Yes During the program stop, the program stop
signal remains applied to the Program
stop signal output. When the program is
continued by pressing Start, this signal is
cancelled. This feature can be used to
provide a signal to operate, e.g., a lamp or
buzzer (connected via a suitable kit).
4 Heating
No No Heating is not activated. Thermostop is
programmed to No. This feature can be
used for e.g., hot rinses.
Yes Heating is activated normally (via the
control).
5 Free
temperature
selection
No No Programmed temperature cannot be
modified before program start.
Yes Temperatures for the first pre-wash and
first main wash can be modified before
program start. Values between Cold and
the programmed temperature can be
selected.
To Next Page
Loading...
Need help?
General
