Technical Information
68
PW 6xx7
Item # in
Table
Item Description Options Details
13 Fill type
Auto load
adjustment
Sets which type of monitoring is used by
control to register water level when filling
machine. Setting options available later in
wash program depend on type of fill
programmed here. When Auto load
adjustment is set, laundry load affects
machine response, e.g., water levels,
dispensed quantities and # of rinses. If,
after creating a program, programmer
changes fill type in associated program
header from Auto load adjustment to
Water quantity in L or Laundry: Suds
ratio in kg/L, control modifies level
settings in blocks accordingly. If a change
is made from Auto load adjustment to
Water height in mm, no modifications
are made in blocks.
13 Fill type
Water quantity in
liters
Sets which type of monitoring is used by
control to register water level when filling
machine. Setting options available later in
wash program depend on fill type
programmed here.
Laundry: Suds
ratio in kg/L
Sets which type of monitoring is used by
control to register water level when filling
machine. Setting options available later in
wash program depend on fill type
programmed here.
14 Release Yes / No
In the Release machine state, only
approved programs can be selected. If
the programmer selects No here, then if
the machine state is set to Release in the
future, the operator cannot select this
program. In such a case, only programs
with the setting Release – Yes in the
program header can be selected. Default
setting: Yes. This is equivalent to key
switch setting A with Profitronic I.
15 Lock Yes / No
Determines if program will be locked
when it is in operation. If it is locked, then
one minute after program has been
started operator cannot stop or interrupt it
with Finish button and door can only be
opened when program has finished.
Default setting: No.
To Next Page
Loading...
Need help?
General
