Technical Information
76
PW 6xx7
No. Program Step Basic Options Setting Options Notes
27
Program stop
signal 2
No No
No stop signal at Program stop
signal output.
Yes
When control reaches a program
stop position, program stop
signal is applied to Program
stop signal output. When Start is
pressed to continue program,
Program stop signal output is
reset. During program stop,
program stop signal remains
applied to Program stop signal
output. When program continues,
this signal is cancelled. This
feature can be used to provide a
signal to operate, e.g., a lamp or
buzzer (connected via a suitable
kit).
28
Drainage path
1
No
No
No drainage takes place. If No is
selected, a spin speed > 70 rpm
cannot be set in Spin program
segment. Spinning with water is
prevented.
Drain Activation of drain valve.
Reservoir
Drained water is transferred to
water recycling (WRG) tank.
Empty reservoir
Control empties water recycling
tank by opening water recycling
intake (K6), drain valve (AVauf)
and water recycling (WRGauf)
valves.
Cleaning
Water is pumped into water
recycling (WRG) tank and
returned to machine.
29 Drain level 1 0 mm
Between 0 mm
and the value in
mm of level 1 or
level 2, whichever
is greater
If Wash time 4 for the current
block has been set to greater
than 0 seconds (should be at
least as long as the drain
interval), Step 29 (“Drain level 1”)
will determine the water level
(mm wc) for drum spinning to
take place during the drain
interval. Spin rhythm and speed
are programmed in “Wash time
4”. Drain level 1 can be set
directly at the machine, but only
between the maximum level in
the current block and 0 mm wc.
With the Miele Profitronic M
programming and archiving
software, however, Drain level 1
can be set between 350 and 0
mm wc. See Section 100-4.3.
30 Wash time 4
Same as Wash
time 1
See Wash time 1 See Wash time 1
To Next Page
Loading...
Need help?
General
