Miele PWM 307 - Low Water Pressure; Water Level Cottons; Water Level Minimum Iron; Cottons Pre-Wash Temp

Supervisor level
74
Low water pressure
If the water pressure is below 100kPa
(1bar), the programme will be can-
celled and the fault message Check
water inlet will appear.
If the on-site water pressure cannot be
increased, activating the setting Low wa-
ter pressurewill prevent the programme
from being cancelled.
Factory default: On
Water level Cottons
You can increase the water level for
the main wash in the Cottonspro-
gramme.
- + 0mm wc (factory default)
- + 10mm wc
- + 20mm wc
- + 30mm wc
Water level Minimum iron
You can increase the water level for
the main wash in the Minimum
ironprogramme.
- + 0mm wc (factory default)
- + 10mm wc
- + 20mm wc
- + 30mm wc
Cottons Pre-wash temp
You can select the temperature for the
pre-wash in the Cottonsprogramme.
- 30°C (factory default)
- 35°C
- 40°C
- 45°C
Wash time Pre-wash
You can increase the duration for the
pre-wash in the Cottonsprogramme.
- + 0min (factory default)
- + 6min
- + 9min
- + 12min