Special features in the program sequence
49
Spinning
Final spin speed
When a program is selected, the maximum spin speed for this wash
program is shown in the display.
You can reduce the final spin speed.
However, you cannot select a final spin speed higher than that shown
in the chart.
Rinse-spin
There is a spin cycle after the main wash and between the rinse cy-
cles. A reduction in the final spin speed will also reduce the rinse-spin
speed as appropriate.
Omitting the final
spin (Rinse hold)
Select the Rinse hold extra option and then the Drain program. After
the last rinse cycle, the water will be pumped away and the Anti-
crease phase will switch on.
Anti-crease
At the end of the program, the drum continues to turn at intervals for
up to 30minutes to help prevent creasing. The washing machine can
be opened at any time.
There is no anti-crease phase at the end of some programs.
To Next Page
Need help?
General
