Supervisor level
53
Operation/display
Language
The display can be set to appear in one of several different lan-
guages. To select the permanent supervisor language you want, go
to the Languages submenu.
When a program is running, you can change the user language using
the sensor button.
Language menu
The display can be set to one of several different user languages.
This setting allows you to determine how languages can be se-
lected.
International
6 languages are available. The sensor button is not active. Note
the settingSet languages.
Language setting
The sensor button can be used to select a language. All lan-
guages are available (factory default).
You can change the order of the first 4 languages. These slots are al-
located to the most commonly used languages.
Standard language
The user language cannot be changed. The user language is the
same as the supervisor language. The sensor button is not ac-
tive.
Set languages
The languages for the Language entry International setting can be
changed.
6 languages can be selected. All languages are available.
If you wish to add a new language to the language menu:
First select the language you want to replace.
All available languages are displayed.
Select and confirm the language to replace the previous language.
The new language appears instead of the old one.
Display bright-
ness
The brightness of the display can be altered. The setting depends on
the various lighting conditions in the place of installation.
It can be set to one of 10 different levels.
To Next Page
Loading...
Need help?
General
