OM-257 798 Page 11
Do not remove or paint over (cover) the label.
Safe20 2012−05
When power is applied failed parts can explode or cause other parts to explode.
Safe26 2012−05
Flying pieces of parts can cause injury. Always wear a face shield when servicing unit.
Safe27 2012−05
Always wear long sleeves and button your collar when servicing unit.
Safe28 2012−05
After taking proper precautions as shown, connect power to unit.
Safe29 2012−05
Drive rolls can injure fingers.
Safe32 2012−05
Welding wire and drive parts are at welding voltage during operation − keep hands and metal objects away.
Safe33 2012−05
Do not discard product with general waste.
Reuse or recycle Waste Electrical and Electronic Equipment (WEEE) by disposing at a designated collection
facility.
Contact your local recycling office or your local distributor for further information.
Safe37 2012−05
Wear hat and safety glasses. Use ear protection and button shirt
collar. Use welding helmet with correct shade of filter. Wear complete
body protection.
Safe38 2012−05
Become trained and read the instructions before working on the
machine or welding.
Safe40 2012−05
>5min
V
V
V
Hazardous voltage remains on input capacitors after power is turned
off. Do not touch fully charged capacitors. Always wait 5 minutes after
power is turned off before working on unit, OR check input capacitor
voltage, and be sure it is near 0 before touching any parts.
Safe43 2012−05
To Next Page
Loading...
