Miller Continuum 500 - Default Chapter; Table of Contents

TABLE OF CONTENTS
SECTION 1 − SAFETY PRECAUTIONS - READ BEFORE USING 1.................................
1-1. Symbol Usage 1.......................................................................
1-2. Arc Welding Hazards 1.................................................................
1-3. Additional Symbols For Installation, Operation, And Maintenance 3.............................
1-4. California Proposition 65 Warnings 4......................................................
1-5. Principal Safety Standards 4.............................................................
1-6. EMF Information 4.....................................................................
SECTION 2 − CONSIGNES DE SÉCURITÉ − LIRE AVANT UTILISATION 5...........................
2-1. Symboles utilisés 5.....................................................................
2-2. Dangers relatifs au soudage à l’arc 5......................................................
2-3. Dangers supplémentaires en relation avec l’installation, le fonctionnement et la maintenance 7.....
2-4. Proposition californienne 65 Avertissements 9..............................................
2-5. Principales normes de sécurité 9.........................................................
2-6. Informations relatives aux CEM 9.........................................................
SECTION 3 − DEFINITIONS 10..................................................................
3-1. Additional Safety Symbols And Definitions 10................................................
3-2. Miscellaneous Symbols And Definitions 12..................................................
SECTION 4 − SPECIFICATIONS 14..............................................................
4-1. Serial Number And Rating Label Location 14................................................
4-2. 350 Model Specifications 14..............................................................
4-3. 500 Model Specifications 14..............................................................
4-4. Dimensions And Weight 14...............................................................
4-5. Environmental Specifications 15...........................................................
4-6. Static Characteristics 15.................................................................
4-7. Duty Cycle And Overheating 16...........................................................
SECTION 5 − INSTALLATION 17................................................................
5-1. Selecting A Location 17..................................................................
5-2. Weld Output Terminals And Selecting Cable Sizes* 18........................................
5-3. Connecting Weld Output Cables 19........................................................
5-4. Remote 10 Wire Feeder Control Receptacle RC2 Information 20................................
5-5. Volt Sense Receptacle RC3 Information 20..................................................
5-6. Supplementary Protector CB1 And Optional Communication Panel 21...........................
5-7. Connection Diagram 21..................................................................
5-8. Electrical Service Guide 22...............................................................
5-9. Connecting 3-Phase Input Power 24.......................................................
SECTION 6 − RECOMMENDED SETUP PROCEDURES 26.........................................
6-1. Welding Circuit 26.......................................................................
6-2. Arranging Welding Cables To Reduce Welding Circuit Inductance 27............................
6-3. 30 Points Of Mechanics In MIG Welding 28.................................................
6-4. Arc Blow 29............................................................................
6-5. Basic Welding Troubleshooting 30.........................................................
SECTION 7 − OPERATION 33...................................................................
7-1. Operator Controls 33....................................................................