OM-257 798 Page 37
SECTION 9 − MAINTENANCE & TROUBLESHOOTING
9-1. Routine Maintenance
! Disconnect power
before maintaining.
. Maintain more often
during severe conditions.
n = Check Z = Change ~ = Clean l = Replace
* To be done by Factory Authorized Service Agent
Reference
Every
3
Months
l Unreadable Labels ~ Weld Terminals nl Weld Cables nl Gun Cables
nl Cords nl Cracked Parts ~ Weld Connections n Tighten Weld Cable
Connections
Every
6
Months
OR
~ Inside Unit
9-2. Blowing Out Inside Of Unit
! Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers.
Ref. 259 119-A
To Next Page
Loading...
