Miller ENPAK - Hydraulic Specifications (Models With Hydraulic Power Source)

OM-261050 Page 14
4-6. Fluid Specifications
Ambient Temperature
F -40 -22 -13 -4 14 32 50 68 (+)
C -40 -30 -25 -20 -10 0 10 20
Engine
Oil 0W -20 5W -30 5W -30 10W -30 10W -30 10W -30 10W -30 10W -30
Full
Synthetic
5W -40 5W -40 10W -40 10W -40 10W -40 10W -40 10W -40
Hydraulic (Models With Hydraulic Power Source)
Oil ISO 15 ISO 15 ISO 15 ISO 15 ISO 32 ISO 32 ISO 32 ISO 32
Oil Viscosity Index VI ≥ 160 VI ≥ 140 VI ≥ 140 VI ≥ 140 VI ≥ 120 VI ≥ 120 VI ≥ 120 VI ≥ 120
Compressor
Oil (Full Synthetic)
Mobil1*
ATF
Mobil1*
ATF
Mobil1
ATF
Mobil1
ATF
Mobil1
ATF
Mobil1
ATF
Mobil1
ATF
Mobil1
ATF
NOTICE − For extreme cold (<−305F), consult with the Miller Service department regarding preheating and suitable lubricants.
* For temperatures below −205F an oil heater for the compressor is required. Consult with the Miller Service department. Failure to preheat the
oil as specified may void the warranty.
See Section 6-5 for more engine cold weather operation information.
Notes