Miller ENPAK - Routine Maintenance

OM-261050 Page 50
11-2. Routine Maintenance
 Replace engine and air compressor oil and filters after the first 50 hours of operation.
Use information displayed on the Alpha−Numeric display to assist in scheduling maintenance (see Section 10-2).
Engine speed is regulated by an electronic governor. Engine speed adjustments may only be performed by the engine manufacturer’s Factory
Authorized Service Agent.
Test safety interlock monthly, see Section 11-6.
Follow the storage procedure in the engine owner’s manual if the unit will not be used for an extended period.
! Stop engine before maintaining.
 See equipment manuals and Maintenance
Label for important start-up, service, and
storage information. Service equipment
more often if used in severe conditions.
Recycle fluids.
 = Check  = Change  = Clean
* If unit is so equipped
Reference
Every
8
Hours
Sections
10-3, 6-4,
8-3, 11-1
 Remote Panel display for
maintenance information
 Coolant Level  Engine Oil Level  Compressor Oil Level
 Truck Fuel Tank Level  Fluid Spills
After
First
50
Hours
Section
11-4, 11-5,
Engine
Manual
 Engine Oil  Compressor Oil  Engine Oil Filter  Compressor Oil Filter
Every
50
Hours
Engine
Manual
 Engine Fuel Pipes And
Clamps
Every
100
Hours
Section
11-3, En-
gine Manual
 Air Cleaner Element  Air Cleaner Hose At En-
gine Air Intake
 Engine Belt Tightness
Every
400
Hours
Engine
Manual,
Section
11-4
 Engine Oil  Engine Oil Filter  or  Fuel Filters
Every
500
Hours
or
Yearly
Section
11-5, En-
gine Manual
 Compressor Oil  Compressor Oil Filter  Compressor Air Filter  Engine Belt
NOTICE − The items highlighted above are registered as emission related critical parts by KUBOTA and the U. S. EPA nonroad
emission regulation. As the engine owner, you are responsible for the performance of the required maintenance on the engine according
to the above instructions.