Miller Multimatic 215 - Primary Logs (Menu 6 Of 10); Error Logs (Menu 7 Of 10)

. A complete Parts List is available at www.MillerWelds.com
OM-272989 Page 37
6-10. Primary Logs (Menu 6 Of 10)
1 Material Thickness Minus (−)
Button
2 Material Thickness Plus (+)
Button
Follow instructions in Section 6-4 to
enter the setup menu.
Primary Logs menu displays power
cycles, 120 volt time, and 240 volt
time.
To exit menu, simultaneously press
and release the Wire/Rod/Tung-
sten Minus (−) button and Material
Thickness Plus (+) button, or turn
unit off and on.
Ref. 271491A
1 2
6-11. Error Logs (Menu 7 Of 10)
1 Material Thickness Minus (−)
Button
2 Material Thickness Plus (+)
Button
Follow instructions in Section 6-4 to
enter the setup menu.
Error Logs screen displays welder
over−temperature errors, shorted
output errors, shorted trigger er-
rors, motor current errors, and
stuck electrode errors.
To exit menu, simultaneously press
and release the Wire/Rod/Tung-
sten Minus (−) button and Material
Thickness Plus (+) button, or turn
unit off and on.
Ref. 271491A
1 2