Miller Multimatic 215 - Parts List; Recommended Spare Parts; Drive Rolls

OM-272989 Page 66
SECTION 13 − PARTS LIST
13-1. Recommended Spare Parts
QuantityDescription
Part
No.
246372 Nozzle, slip type .500 orf flush 1..................... .. ...................................
♦087299 Tip, contact scr .023 wire x 1.125.................... .. ..................................
♦000067 Tip, contact scr .030 wire x 1.125.................... .. ..................................
♦000068 Tip, contact scr .035 wire x 1.125.................... .. ..................................
♦000069 Tip, contact scr .045 wire x 1.125.................... .. ..................................
♦194010 Liner, monocoil .023/.025 wire x 15ft (consisting of) 1.................... .. .................
♦194011 Liner, monocoil .030/.035 wire x 15ft (consisting of) 1.................... .. .................
♦194012 Liner, monocoil .035/.045 wire x 15ft (consisting of) 1.................... .. .................
079975 O-RING, .187 ID x .103CS rbr 1..................... .... .................................
To maintain the factory original performance of your equipment, use only Manufacturer’s Suggested
Replacement Parts. Model and serial number required when ordering parts from your local distributor.
13-2. Drive Rolls
Part No. Wire Diameter in. (mm)
261157 .024 (.6), .030/.035 (.8 and .9) (Standard) and .030/.035 (.8 and .9) (VK Groove)
♦202179
.024 (.6) and .030/.035 (.8 and .9) (Standard)
♦202926 .030/.035 (.8 and .9) and .045 (1.2 VK Groove)
♦ Optional
. A complete Parts List is available on−line at www. MillerWelds. com