EasyManua.ls Logo

Miller PRO 300 - SECTION 3 - DEFINITIONS; 3-1. Warning Label Definitions

Miller PRO 300
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OM-4422 Page 9
SECTION 3 − DEFINITIONS
3-1. Warning Label Definitions
3/96
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Do not smoke and keep
matches and flames away from
battery.
3 Sparks can cause battery
gases to explode. Battery
explosion can blind and injure.
Wear a face shield.
4 Battery acid can burn skin. Do
not spill acid.
5 Read Owner’s Manual.
6 Wear rubber gloves.
7 Dead battery
8 Engine block
9 Fully charged battery
10 Do not connect last negative
cable to dead battery − connect
instead to engine block.
11 Jumper cables − observe
polarity and make connections
in numbered sequence shown.
12 Once dead battery is charged,
disconnect cables in sequence
shown.
1
S-176 108
+ −
+ −
1
4
2
3
−+
+ −
+ −
4
1
3
2
2 3 4 5 6
10
11
7
89 12
S-176 106
3/96
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Moving parts, such as fans,
rotors, and belts, can cut
fingers and hands and cause
injury. Keep away from moving
parts.
1
2
6/02
1
1 Warning! Watch Out! There
are possible hazards as
shown by the symbols.
2 Ether will damage engine. Do
not use ether as a starting aid.
3 Read Owner’s Manual.
4 Use glow plugs for 10−25
seconds to aid starting in cold
weather.
2 3 4

Table of Contents