Millipore Milliflex Oasis - Table of Contents

Page 2 of 32
Notice
The information in this document is subject to change without notice and should not
be construed as a commitment by Merck KGaA, Darmstadt, Germany. Merck KGaA,
Darmstadt, Germany assumes no responsibility for any errors that may appear in
this document. This manual is believed to be complete and accurate at the time of
publication. In no event shall Merck KGaA, Darmstadt, Germany be liable for incidental
or consequential damages in connection with, or arising from, the use of this manual.
Table of Contents
Introduction 3
1. Components 4
1.1 Required items 4
1.2 Description of items 5
1.3 Touch switch 6
2. Hardware installation 7
3. Testing 9
3.1 Filtration units 9
3.2 Media plates 10
3.3 Testing 10
3.4 Waste 13
4. Cleaning & maintenance 14
4.1 Cleaning & maintenance table 14
4.2 Surface sanitizers and internal ow
sanitizers table 14
4.3 Filtration head cleaning 15
4.4 Pump surface cleaning 15
4.5 Pump rinsing 15
4.6 Filtration head external gasket cleaning 15
4.7 Pump internal ow sanitization 16
4.8 Filtration head complete cleaning 17
4.9 Filtration head gaskets and check valve
replacement 19
4.10 Sanitization kit gaskets and valve
replacement 19
5. Performance verication 20
6. Use of multiple pumps 21
6.1 Material needed 21
6.1.1 Two pumps connected 21
6.1.2 Three pumps connected 21
6.2 Installation 21
7. Culture media growth promotion test 24
8. Milliex
®
cassettes 25
9. System specications 27
10. Ordering information 28
11. Troubleshooting 30
12. Operator & equipment safety instructions 31
13. Technical assistance 31