Millipore Milliflex Oasis - Using Multiple Pumps; Multiple Pump Setup Materials; Multiple Pump Installation Guide

Page 21 of 32
6. Use of multiple pumps
Up to three pumps can be connected
providing the following benefits:
• Higher throughput
• Use of single power supply
• Daisy chain start: up to six samples
filtered with a single push of a button
6.1 Material needed
6.1.1 Two pumps connected:
• Two Milliflex Oasis
®
pumps (item
MMSYSTMM1)
• Milliflex Oasis
®
electrical cable for
connecting two pumps (item MMCABLEMM)
• Milliflex Oasis
®
power supply, the item
number is specific to defined regions:
- Australia: item MMPWRSPAU
- Brazil: item MMPWRSPBR
- China: item MMPWRSPCN
- Denmark: item MMPWRSPDK
- Europe: item MMPWRSPEU
- Switzerland: item MMPWRSPSZ
- India: item MMPWRSPIN
- UK: item MMPWRSPUK
- Japan: item MMPWRSPJP
- USA: item MMPWRSPUS
- South Africa: item MMPWRSPZA
Optional: Milliflex Oasis
®
T connectors for
tubing (item MMTCNNECT)
6.1.2 Three pumps connected:
• Three Milliflex Oasis
®
pumps (item
MMSYSTMM1)
• Two Milliflex Oasis
®
electrical cables for
connecting two pumps (item MMCABLEMM)
• Milliflex Oasis
®
power supply, the item
number is specific to defined regions
Optional: Milliflex Oasis
®
T connectors for
tubing (item MMTCNNECT)
6.2 Installation
The pumps must be installed on a level
surface to ensure good sample volume
readings.
• Take the pump bodies and the tubing out
of the package with care
• Take out the accessory bags
Optional: the accessory bag contains four
stickers, select your preferred sticker and
stick it carefully to the specific groove on
each pump.
Figure 44: pump sticker set up