POWER
Before making the power connection, ensure proper voltage selection.
Never operate the XPL+ with the enclosure lid open,
or with the ground ( earth ) wire disconnected.
Ensure that any connected alarm or control
equipment is disabled until satisfactory system
operation and performance is verified.
The equipment must be protected by a 15 A fuse or
circuit breaker in the building installation.
A circuit breaker or switch in the building installation, marked as the
disconnect switch, shall be in close proximity to the equipment
and within easy reach of the operator.
SW1 switch shown in the
‘OFF’ position. Select
appropriate voltage.
100/115/200/230 V
50 / 60 Hz
select voltage via SW1.
PL-532 18
To Next Page
Loading...
Need help?
General
