MEASUREMENT VERIFICATION PARAMETERS ( P710 to P713 )
P710 FUZZ FILTER
Use this feature to stabilize the reported material level, due to material level fluctuations ( such
as a rippling or splashing liquid surface ), within the Echo Lock Window ( P713 ).
This value (in % of Span, P007) is automatically altered when Measurement Response
( P003 ) is altered. ( See TECHNICAL REFERENCE Measurement Response ).
The higher the value entered, the greater the fluctuation stabilized. ( 0 = off )
values: 0 to 100
P711 ECHO LOCK
Use this feature to select the measurement verification process.
This value is automatically altered when Material ( P002 ) and/or Measurement Response
( P003 ) is altered. ( See Measurement Response ).
When set for "maximum verification" or "material agitator", a new measurement outside of
the Echo Lock Window ( P713 ), must meet the sampling criterion (P712).
For " total lock ", Echo Lock Window (P713) is preset to "0". The XPL+ continuously
searches for the best echo according to the algorithm chosen (P820). If the selected echo
is within the window, the window is then centered about the echo. If not, the window widens
with each successive shot until the selected echo is within the window. The window then
returns to its normal width.
When Echo Lock is "off", the XPL+ responds immediately to a new measurement as
restricted by the Max Fill / Empty Rate ( P700 / P701 ), however measurement reliability
is affected.
values: 0 = off
1 = maximum verification
2 = material agitator
3 = total lock
TECHNICAL REFERENCE
TECHNICAL REFERENCE
ENHANCED PARAMETERS
PL-532 61
To Next Page
Loading...
Need help?
General
