ENHANCEMENT PARAMETERS
This section identifies all XPL+ operator programmable features designed for altering operation to suit
individual operator preferences or overcome measurement difficulties.
Typically, these parameters are only altered as directed by the TROUBLESHOOTING GUIDE . If RUN mode
performance requires improvement, access and alter the following parameters as required.
Otherwise, proceed to OPERATION .
PARAMETER CATEGORY PURPOSE PAGE
Data Logging to view previous maximum Temperature records 50
Profile Records intended for use by Milltronics Service personnel 51
Installation Records to identify length of service and power failure occurrence 54
Range Calibration to compensate for measurement offset and/or sound velocity 55
Temperature Compensation to override automatic temperature compensation features 57
Rate to override Measurement Response (P003) 59
Measurement Verification to override Measurement Response (P003) 61
Scanning to override automatic scanning delay or use Aux. Transducer 63
Display Parameters to override the preset display operating characteristics 65
SmartLinx Parameters communications 67
Echo Processing to troubleshoot false echo detection 68
Advanced Echo Processing intended for use by Milltronics Service personnel 70
Test Parameters intended for use by Milltronics Service personnel 78
Measurement Parameters to verify Application Parameter programming 80
Master Reset to reset numerous Parameter Values 81
When an Enhancement Parameter is altered, return to the RUN mode to verify the performance
desired is achieved, before making any other changes.
TROUBLESHOOTING GUIDE
OPERATION
ENHANCED PARAMETERS
PL-532 49
To Next Page
Loading...
