PERFORMANCE TEST RESULTS
Monitor system performance carefully, under all anticipated operating conditions.
A. When the XPL+ performs exactly as required, programming is complete.
B. If the XPL+ measurements are accurate and reliable, however alternate Reading units, failsafe,
SAM-20 relay, or AO-10 mA output operation is desired, proceed to APPLICATION PARAMETERS .
C. Should system performance not meet installation requirements, (or the "LOE" display persists after
start up), proceed to the TROUBLESHOOTING GUIDE .
If all operating conditions cannot be observed during the System Performance Evaluation, refer to
ENHANCEMENT PARAMETER S Reading Measurement (P920). Perform a Reading Measurement
simulation to verify programming.
Conduct a System Performance Evaluation following any installation modification or Quick Start, Application,
or Enhancement Parameter alteration.
With programming complete, copy all parameter alterations to the Programming Charts. In the program mode,
all altered parameters may be quickly scroll accessed (skipping by parameters left at preset values).
Connect (or enable) process control/alarm equipment to the XPL+ only after
satisfactory performance is verified for all possible operating conditions.
For normal operation, return to the RUN mode. The XPL+ will perform reliably, with little or no maintenance.
APPLICATION PARAMETERS
TROUBLESHOOTING GUIDE
ENHANCEMENT PARAMETERS
PL-532 32
To Next Page
Loading...
