P906 COMMUNICATIONS
to test the Milltronics proprietary communications circuit.
Before activating this feature, connect terminal block contacts 42 to 45 and 43 to 46.
On successful test completion, "PASS" is displayed. If "FAIL" is displayed, repeat the test.
( The first test performed sets up the auto polarity function ).
P907 PROGRAMMER INTERFACE
to activate the programmer interface ( two way infrared communications ) test.
On successful test completion, "PASS" is displayed. Otherwise, "FAIL" is displayed.
P908 SCANNER
to activate the scanner test.
When activated, the on board transducer scanning relays energize
and de-energize in sequence.
( The transmit pulse is not supplied to the transducer terminals during this test ).
P910 RELAY
Access this parameter to display the current state of the specified SAM-20 relay.
to alter the relay state ( energized / de-energized ) or enter the value
corresponding to the specific relay state desired.
values: 0 = de-energized
1 = energized
P911 mA OUTPUT VALUE
Access this parameter to display the current value of the specified AO-10 mA output.
Additionally, this feature may be used to enter a desired value. The mA output is immediately
forced to the value entered regardless of any restrictions programmed.
values: 0.000 to 25.00
P912 TRANSDUCER TEMPERATURE
Access this parameter to display the vessel temperature in °C ( as monitored by the
connected temperature sensing transducer ). "Err" is displayed if the transducer is not
equipped with an integral temperature sensor.
values: -50 to 150
P913 SENSOR TEMPERATURE
Access this parameter to display the vessel temperature in °C ( as monitored by the connected
temperature sensor ). "OPEn" is displayed if a TS-3 is not connected.
values: -50 to 150
ENHANCED PARAMETERS
PL-532 79
To Next Page
Loading...
