MIMAKI CJV150-107 - Chapter 5 Maintenance Overview

This chapter
describes the items required to use this machine more comfortably, which are the
methods for the daily care, the maintenance of the ink cartridges etc.
Maintenance .................................................5-2
Precautions for Maintenance ...................... 5-2
About Cleaning Solution.............................. 5-2
Cleaning the Exterior Surfaces ................... 5-2
Cleaning the Platen ..................................... 5-2
Cleaning the Media Sensor ......................... 5-3
Cleaning the Media Press ........................... 5-3
About MAINTENANCE MENU ......................5-4
MAINTENANCE MENUs at-a-glance .......... 5-5
Maintaining the Capping Station ...................5-6
Cleaning the Wiper and Cap ....................... 5-6
Washing the Head Nozzle ........................... 5-7
Washing the Ink Discharge Passage .......... 5-8
When the Machine Is Not Used for a
Long Time ................................................... 5-8
Cleaning the Ink Head and the Area
around It ......................................................5-10
Nozzle Recovery Function ..............................5-11
Reset the set value ................................... 5-12
Automatic Maintenance Function ................5-12
Setting the Refreshing Intervals .................5-12
Setting the Tube Wash Intervals ................5-13
Setting the Cleaning Intervals and Type ....5-13
Fill up Ink .....................................................5-14
White Ink Maintenance ................................5-14
Replacing consumables ..............................5-15
Replacing the wiper ...................................5-15
If a Waste Ink Tank Confirmation Message
Appears .....................................................5-15
Replacing the waste ink tank before the waste ink
tank confirmation message is displayed
..........5-17
Replacing the Cutter Blade ........................5-17
Replacing and Adjusting the Cutter Blade ..5-18
Replacing the cutter ...................................5-18
Adjusting the Cutter Blade .........................5-18
Replacing the cutter other than supplied
one .............................................................5-18
Adjusting blade edge of cutter other than
supplied one ..............................................5-19
Chapter 5
Maintenance