Chapter 5 Maintenance
5-3
5
2
Cleaning the Media Sensor
The media sensors are located on the platen in the
backside and the bottom surface of the head. When the
sensor is covered with dust, etc., it may cause false
detection of media.
Using a cotton swab, remove the dust, etc. accumulated
on the surface of the sensor.
When cleaning the sensor on the lower surface of the
head is cleaned, move the carriage to the left end by the
operations of step 1 of P.5-10 “Cleaning the Ink Head and
the Area around It”, and clean it.
Cleaning the Media Press
When the media press is covered with lint, dust, etc., a
media cannot be fed normally during printing or dust
sticks to the nozzles, which may result in abnormal
printing.
Clean the media press regularly.
• Don’t touch the cutter around the media sensor.
Sharp cutter tip may injure you.
To Next Page
Loading...
