Chapter 3 NOZZLE CHECK
3-20
About NOZZLE CHECK MENU
Set operations concerning the nozzle missing detection function.
INFORMATION MENU table
Function name Set value Default Meaning
Printing Check ( P.3-22) ON/OFF OFF
Set this when you want to conduct nozzle check at the
beginning of online printing.
(ON)
Check
Interval
LENGTH 0.1 to 50.0m 30.0 m Conducts nozzle check at each set length.
FILE 1 to 100 30 file Conducts nozzle check at each set number of files.
*1
*1. When the set length is reached during printing, nozzle check is conducted at the start of the next printing.
Action
CLEANING
OFF/ SOFT/
NORMAL/ HARD
SOFT Sets the type of cleaning performed during recovery work.
RETRY
COUNT
0 to 3 1 Repeats the retry operation for the set number of times.
NOZZLE RECOVERY
(P.3-22)
ON/OFF OFF Set this when you want to conduct automatic nozzle recovery.
Judgement Condition
(P.3-22)
1 to 180 1
Sets how many missing nozzles are detected for “Nozzle
Missing” judgment to be made according to each color.
(Maximum 16 per 1 nozzle line)
*2
*2. Depending on the print conditions, nozzle recovery is not applied in some cases.
: Press this to select INFORMATION MENU, or to switch to
the previous screen.
: Press this to switch to the next screen.
: Use these to select a setting item.
: Press this to confirm a setting, etc..
NCU MENUs at-a-glance
To Next Page
Loading...
