3-15
3
2
2
2
Chapter 3 Mchine setting
3
Press to select “SPACE FEED
MODE” , and press the key.
4
Press to select a set value, and
press the key.
INTERMITTENT：Perform intermittent feed
operation of the path division
unit
CONTINUOUS ：Feed the no data part at a time
5
Press the key several times to
end the setting.
Set the network
You can also perform network setting with “Network
Configurator”, the tool to perform network setting of
Mimaki’s product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (http://eng.mimaki.co.jp/download/).
1
Press the
(MENU)
(twice)
key in LOCAL.
• MACHINE SETUP MENU will be displayed.
2
Press the
(<<)
.
3
Press to select “NETWORK” ,
and press the key.
4
Press to select “CHECK IP
ADDRESS” , and press the key.
• The IP address currently used by this machine is
displayed.
• When you have finished the check, press the
[ENTER] key.
5
Press to select “CHECK MAC
ADDRESS” , and press the key.
• The MAC address currently used by this machine
is displayed.
• When you have finished the check, press the
[ENTER] key.
6
Press to select “DHCP” , and
press the key.
7
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• When it is ON, the IP address given by the DHCP
server is used.
8
Press to select “AutoIP”, and
press the key.
9
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• When it is ON, the IP address is determined by
the AutoIP protocol. However, DHCP is ON,
DHCP has priority.
10
Press to select “IP ADDRESS” ,
and press the key.
11
Press to select a set value, and
press the key.
• Set value : ON/ OFF
• Both of DHCP and AutoIP is OFF, you can set IP
Address. For other than above, proceed to the
Step 14.
12
Press the key .
• The setting items DEFAULT GATEWAY, DNS
ADDRESS and SUBNET MASK will be displayed.
• Both of DHCP and AutoIP is OFF, you can set
DEFAULT GATEWAY/ DNS ADDRESS/ SUBNET
MASK. For other than above, proceed to the Step
14.
13
Press the several times to select
setting item, and press the key.
14
Press to select a set value, and
press the key.
15
Press the key several times to
end the setting.
Setting event mail function
Set the function to send e-mails to the set e-mail address
when events such as cutting start/ end and stop due to an
error.
You can also perform network setting with “Network
Configurator”, the tool to perform network setting of
Mimaki’s product. To download the Network Configurator,
check " Driver / Utility" on the download page at Mimaki
Engineering (http://eng.mimaki.co.jp/download/).
• After connecting with the network, it takes time until
the IP address is determined. If the IP address has
not been determined, “0.0.0.0” is displayed.
• To reflect network setting, once turn off the power
supply and turn it on again.
• Disclaimer
• The customer is responsible for the communication fee for
Internet communication such as e-mail notification.
• The notification by the event mail function may not be
delivered due to Internet environment, failure of the device/
the power supply, etc. Mimaki has absolutely no
responsibility for any damages or loss resulting from non-
delivery or delays.
• You can use event mail function by connecting
LAN to this machine. Please prepare for LAN
cable connection beforehand.
• Not compatible with SSL communication.
To Next Page
Loading...
