4-9
Chapter 4 Cutting Funcion
4
2
2
Cutting MENU table
• For each setting item below, you can set it so that the machine may operate according to the value specified when you
printed from your RIP software in the connected host PC.
• Set Item : DRYING TIME/ MARGIN (LEFT and RIGHT)/ VACUUM FAN/ FEED SPEED
• When you operate the machine according to the contents specified with the RIP software, set each
• item to “Host” when registering this machine type. When you set it other than “Host”, the machine operates according to
the machine setting.
• For the specifying method with the RIP software, refer to the operation manual of the RIP software.
Function name Outline
TP DETECT ( P.4-6)
MARK DETECT
When you cut the data with registration marks, you must set
without fail.
FORM
SIZE
OFFSET X
OFFSET Y
DETECT END KEY START
SENSOR LEVEL
MARK FILL UP
CUT MODE ( P.4-10) This is to set the cutting quality.
COPY ( P.4-10)
This function performs cutting for the received data on two or
more sheets.
Tool Change ( P.2-24, P.2-24) You select this function when you replace the tool.
SETUP SUB MENU
DIVISION CUT ( P.4-11)
You can cut the data bigger than the sheet width by dividing it.
With division cut, you can make settings for the width direction
(Y) and feed direction (X).
UP SPEED ( P.4-13)
This is to set the speed of sheet and carriage movement when
the tool is up. Setting the speed lower makes the sheet
misalignment reduced at the time of long sheet feeding.
DUMMY CUT ( P.4-13)
The blade edge is made to turn to a specific direction before
starting cutting, which allows dummy cutting.
SHEET TYPE ( P.4-13) This is to set the types of sheet according to the sheet you use.
ADJ PRS OFFSET ( P.4-13)
This is used to expand the value in such a case as when the
beginning and end part of the cut are left cut.
OVER CUT ( P.4-13)
By over lapping the start point and the end point arbitrarily, you
can make the media without uncut area.
SETUP RESET ( P.4-14) The already configured settings are initialized.
MAINTENANCE
MARK SENSOR ( P.4-15) This is for adjusting the registration mark sensor.
SAMPLE CUT ( P.4-17)
In case that normal data cutting cannot be performed etc.,
perform cutting with the sample stored in this machine to find
out the cause of cutting error.
AUTO CUT ( P.4-17) Cutting a medium into multiple pieces with a certain length.
ORIGIN OFFSET ( P.4-18)
To print & cut the data without register marks, adjust the
misalignment between a printed image and the cutting line.
To Next Page
Loading...
