4-11
Chapter 4 Cutting Funcion
4
2
2
SETUP SUB MENU
The SETUP SUB MENU offer convenient functions that
you can use in cutting.
The following items are available in the sub menus.
Setting the DIVISION CUT
When you set DIVISION CUT for the width direction (y),
you can cut the data bigger than the media width by
dividing it.
In addition, when you set DIVISION CUT for the feeding
direction (X), you can cut the long data by dividing it and
you can prevent cutting misalignment due to media
meandering.
Set the Y direction (width direction)
DIVISION CUT
1
Press the
(MENU)
(>>)
key in LOCAL.
• Cuttibg MENU will be displayed.
2
Press
(>>)
.
3
Press to select the “SETUP SUB
MENU”, and press the key.
4
Press to select the “DIVISION
CUT”, and press the key.
5
Press to select “Y”, and press
the key.
• If you select “OFF”, setting for division cutting will
not be carried out. Proceed to step 9.
6
Press to select “FRAME CUT”,
and press the key.
7
Press to select a set value, and
press the key.
• Set value : ON, OFF
• Select “ON” for the frame cut.
8
Press to select “MARK CUT”,
and press the key.
9
Press to select a set value, and
press the key.
• Set value : ON, OFF
• Select “ON” for the mark cut.
10
Press the key several times to
end the setting.
Function name Outline
DIVISION CUT
(P.4-11)
You can cut the data bigger than the sheet
width by dividing it.
With division cut, you can make settings for
the width direction (Y) and feed direction
(X).
UP SPEED
(P.4-13)
This is to set the speed of sheet and
carriage movement when the tool is up.
Setting the speed lower makes the sheet
misalignment reduced at the time of long
sheet feeding.
DUMMY CUT
(P.4-13)
You can the blade edge is made to turn to a
specific direction before starting cutting,
which allows dummy cutting.
SHEET TYPE
(P.4-13)
Set this according to the weight of the
media you have set. When this is set to
"HEAVY", the maximum cutting speed is
set low.
ADJ PRS
OFFSET
(P.4-13)
This is used to expand the value in such a
case as when the beginning and end part
of the cut are left cut.
OVER CUT
(P.4-13)
By over lapping the start point and the end
point arbitrarily, you can make the media
without uncut area.
SETUP RESET
(P.4-14)
Reset the setting values to the initial state.
With the DVISION CUT function, you can use the
following convenient functions too.
• Perform a frame cut:
Together with the cut data, the machine
automatically cuts out the frame fitted to the size
of the cut data.
• Put a mark for leaving a margin for gluing:
You can put a “mark” for showing the point for
gluing together the DIVISION CUT medias.
To Next Page
Loading...
