2-15
2
2
2
2
2
Chapter 2 Basic Operation
Setting leaf media
Unlike roll media, leaf media does not need to be retained
with the roll holders.
1
Raise the clamp lever.
2
Insert the leaf media between the platen
and the pinch rollers.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
3
To print, hold the media with the media
press gently.
• Set the media so that no media sticks out from the
right end pinch roller to the right side.
• When using a thick media, remove the media
press from the media before printing.
• You do not need to use the media holder for
cutting.
4
Push down the clamp lever.
• Set the media straight.
5
Press the key.
6
Press the key to select "LEAF" .
7
The media detection is started.
(1) The media width is detected.
(2) The media is fed then the rear end of media
is detected.
(3) It returns to the Local when the detection is
completed.
• Set the pinch roller so that the media is held at
equally spaced intervals. If the pinch rollers cannot
be set at equally spaced intervals, start over from
Step 2.
• Ensure there is a dead space of 5 mm or above at
each end of the media. P.2-10).
• Set the media on the black part of the platen so
that it comes out approximately 40mm. If it is
shorter than that, it may not be able to perform the
media detection.
• After setting the media in place, set the pinch roller
pressure, referring to P.2-13 “Setting the pinch
roller pressure”.
To Next Page
Loading...
