iii
Setting Auto Cleaning........................................................................ 3-9
Setting Interval wiping ....................................................................... 3-9
About MACHINE SETUP MENU ............................................... 3-10
MACHINE SETUP MENU table ...................................................... 3-11
Setting a AUTO Power-off............................................................... 3-12
Setting Take-up unit ........................................................................ 3-12
Setting the Display of Media Residual............................................. 3-13
Setting the Display of Media Detection ........................................... 3-13
Setting a LANGUAGE ..................................................................... 3-13
Setting Time .................................................................................... 3-14
Setting Unit (Temperature/ Length)................................................. 3-14
Setting a KEY BUZZER................................................................... 3-14
Setting the CONFIRM. FEED.......................................................... 3-14
Setting the SPACE FEED MODE.................................................... 3-14
Set the network ............................................................................... 3-15
Setting event mail function .............................................................. 3-15
Initializing the Settings..................................................................... 3-19
About NOZZLE CHECK MENU .................................................3-20
INFORMATION MENU table........................................................... 3-20
Printing Check Flow ........................................................................ 3-21
Printing Operations at “Nozzle Missing” Judgment and Error
Occurrence...................................................................................... 3-21
Setting the Printing Check............................................................... 3-22
Setting the NOZZLE RECOVERY................................................... 3-22
Setting the Judgement Condition .................................................... 3-22
About INFORMATION MENU ....................................................3-23
INFORMATION MENU table........................................................... 3-24
Displaying the Information............................................................... 3-24
Chapter 4 Cutting Funcion
Cut Out Data with Registration Mark ........................................... 4-2
The Flow of Cutting out the Registered Data .................................... 4-2
Enter the registration mark detection mode ...................................... 4-2
Precautions in inputting data with registration marks........................ 4-2
Setting of Detecting the Registration Marks...................................... 4-6
About CUTTING MENU ...............................................................4-8
Cutting MENU table........................................................................... 4-9
Setting the CUT MODE .............................................................4-10
perform multiple Cuttings (Copy function) ................................. 4-10
SETUP SUB MENU ................................................................... 4-11
Setting the DIVISION CUT.............................................................. 4-11
Make the media without uncut area (OVER CUT function)............. 4-13
Other SETUP SUB MENU .............................................................. 4-13
SETUP RESET ............................................................................... 4-14
Maintenance Function ............................................................... 4-15
Maintenance of Mark Sensor .......................................................... 4-15
Perform SAMPLE CUT to Find out the Cause of Cutting Error....... 4-17
Cutting a Medium into Multiple Pieces with a Certain Length ......... 4-17
Cutting out Data without Register Marks (PC ORIGIN OFFSET) ... 4-18
Setting the Scale Adjust .................................................................. 4-19
To Next Page
Loading...
