MIMAKI JFX-1631/1615 Plus - Page 102

Regular maintenance for white ink
4-20
7
Slowly shake the white ink cartridge more than twenty times right and left.
• To prevent ink from leaking when you shake the cartridge, wear gloves and firmly cover the A part of the
upper surface of the cartridge and the B part of the bottom surface of the cartridge with paper towels.
Then, shake it more than twenty times right and left so that ink flows inside the cartridge.
8
When a screen shown in the right is displayed,Return the
white cartridge to the ink station.
• As shown in the drawing, set an ink cartridge turning up a side
containing the IC chip.
9
Press the key.
• Ink filling starts.
• A message shown in the right is displayed after completion of white
ink filling.
10
Press the key several times to finish.
• If you shake it too strong, the pack inside may be damaged and it may cause ink
leakage. Therefore, perform this carefully.
• If the remaining amount of ink is less, ink in the cartridge cannot be beaten enough. Tilt
the cartridge until it becomes vertical.
A part
(the place to stick a
needle)
B part
(the slot on the
bottom)
Cover with paper towel firmly and shake ink slowly
Repeat
this
A part
WH I T E M A N T
SET CARTR I DGE
IC chip
FILL UP
PLEASE WA I T
MA I NTENANCE
WH I T E M A N T < e n t >
ENTER
END