MIMAKI JFX-1631/1615 Plus - Each setting; Setting of priority

3-11
Each setting
3
Useful Function
Setting of priority
Priority of setting of this device or that of the computer on the following items respectively is selected.
Items to be selected : PRINT MODE/ INK LAYERS
1
Press the key in the local mode.
2
Select the [SET UP] by pressing the or key.
3
Press the key.
4
Select the [PRIORITY] by pressing the or key.
5
Press the key.
• Drawing type setting screen is displayed.
6
Select the “HOST” or the “PLOT” by pressing the
or key.
• HOST : Setting of the computer has the priority.
PLOT : Setting of this device has the priority.
7
Press the key.
8
Set other items with the same manner as 6, 7.
9
Press the key several times to end the setting.
• Set value remains after cutting the power.
• When you use the RIP software “RasterLinkPro5”, the priority becomes valid only for “INK LAYERS”
setting. Even if you set “PLOT” to the priority of “PRINT MODE”, drawing is performed according to the
setting value in the RasterLinkPro5.
FUNCT I ON
VIEW <ENT>
FUNCTION
FUNCT I ON
SET UP <ENT>
SET UP
FEED COMP . <en t >
ENTER
SET UP
PR I OR I TY . < e n t >
SET UP
PR I NT MODE : HOST
ENTER
SET UP
PR I NT MODE : PLOT
ENTER
END