MIMAKI JFX-1631/1615 Plus - Each setting; Setting the work change

3-12
Setting the work change
Set whether to return to the local mode or keep the remote mode after online drawing.
(Supported from the firmware ver.2.70)
1
Press the key in the local mode.
2
Select the [SET UP] by pressing the or key.
v
3
Press the key.
4
Select the [WORK CHANGE] by pressing the or
key.
5
Press the key.
6
Pressing , select the work change setting
(OFF or ON).
• OFF : Keeps the remote mode after online drawing.
(draws next drawing data over a drawn face while receiving)
• ON : After online drawing, the Y bar moves to the view position set in advance ( P.2-13 “Evacuation
of Y-bar from the table”). When the Y bar moving has been completed, the machine returns to
LOCAL.
v
7
Press the key.
• When you set this to “OFF” in the Step 6, proceed to the Step 10.
8
Pressing , select the vacuum setting (OFF or
ON).
• OFF : After online drawing, turns off the vacuum and then returns to LOCAL.
• ON : After online drawing, returns to LOCAL with the vacuum is ON.
v
9
Press the key.
10
Press the key several times to end the setting.
FUNCT I ON
VIEW <ENT>
FUNCTION
FUNCT I ON
SET UP <ENT>
SET UP
FEED COMP . <en t >
ENTER
SET UP
WO R K C H A N G E < e n t >
SET UP
WO R K C H A N G E : O F F
ENTER
SET UP
WO R K C H A N G E : O N
SET UP
VACCUM : ON
ENTER
SET UP
VACCUM : OFF
セッテイ
ワーク チェンシ ゛
:ON
ENTER
END