MIMAKI JFX-1631/1615 Plus - Changing origin; Changing with the JOG keys

3-2
Changing origin
The default origin position can be changed.
There are following 2 changing methods.
Changing origin with JOG keys
1
Press the keys
in the local mode.
• The origin setting mode starts
• A red light pointer mark [ ] is projected on the table or the media.
2
Move the light pointer mark by pressing the
keys.
• Move the light pointer mark to the position to set a new origin.
3
Press the key when the drawing origin is
determined.
• The origin is changed.
• The setting value for the origin set with the JOG keys is cleared by cutting the power.
Changing with the JOG keys Changing with the ÅgORIGINÅh in
the FUNCTION menu
OR I G I N SE T UP
0.0 ---
OR I G I N SE T UP
500 . 0 600 . 0
Origin position
(back and forth)
Origin position
(right and left)
** ORIGIN **
ENTER