MIMAKI JFX-1631/1615 Plus - Turning the power ON

2-4
Turning the power ON
1
Press the power button
• Press the power button n the left side of the operation panel to
light.
• When the main power switch is not set to ON, the power is not
connected even if the power button is pressed. If the lamp
does not light even if the button is pressed, check the main
power switch on rear side of this unit.
• When the power is switched on, the LCD displays the firmware
version number.
• Initial operation is started.
2
Press the key.
• Local Mode starts.
3
Turn the power of connected computer ON.
• When the power is turned ON, the Y-bar moves. To avoid injuries, keep your hands away from the table.
• If the temperature in the hot water device has not reached the predetermined value, a message is
indicated. In this case, drawing is disabled. It is enabled when the error indication has disappeared.
• When turning on / off with the main power switch on the left side of the machine, turn it off, wait more
than five seconds, and then turn it on.
JFX- 1631 s t a r t -up
ver . * . * *
PLEASE WA I T
<LOCAL>
2.5mm
ENTER