– 5.17 –
5-3-5. DEFAULT SET
[Function]
Parameter settings are reset to initial values.
When the “Set parameter” is under execution, the following situation takes place.
• The setting items (the drawing method, the number of ink layers etc.) are reset to the
initial values.
• “PRINTadjust2” that is released to the users is reset to the initial value.
• System parameter No.62 Adjusting function extension =0 (Adjusting function: CLOSE)
• The display is initialized (English display).
[Operation]
1) Select the ‘‘ADJUSTMENT” .
Press the
ENTER
key.
2) Select the ‘‘DEFAULT SET’’ pressing the
FUNCTION
key.
Press the
ENTER
key.
3) Select the parameter pressing the
or
key.
SETUP PRM
INK PRM. 1
INK PRM. 2
INK PRM. 3
MAINTE PRM
SERVO PRM
ADJUST PRM
SHIPPINGset (Not used in the field.)
4) Press the
ENTER
key, display the check
messaage.
5) Press the
ENTER
key, and the parameter
settings are reset to the initial values.
FUNCTION
# ADJUST < ENT >
# ADJUST
DEFAULT SET < ent >
# DEFAULT SET
SETUP PRM < ent >
# DEFAULT SET
INK PRM. 1 < ent >
# DEFAULT SET
INK PRM. 2 < ent >
# DEFAULT SET
SHIPPINGset < ent >
SETUP PARAMETER
INITIAL. OK? : ent
# DEFAULT SET
SETUP PRM < ent >
--------- Not used in the field.
○○○