Warning / Error Messages
5-9
1
1
1
1
5
Troubleshooting
Error messages
When an error message is displayed, eliminate the error according to the chart below.
If the same error message appears again, contact your dealer or an office of MIMAKI to call for service.
Message Cause Solution
An error occurred in the circuit
board system. (ROM)
Turn off the power to the machine and
turn it on after a while.
If the same error message appears
again, contact your local distributor to
call for service.
An error occurred in the circuit
board system. (RAM)
An error occurred in the circuit
board system. (POWER +5V)
An error occurred in the circuit
board system. (POWER +24V)
An error occurred in the circuit
board system. (POWER +42V)
An error occurred in the circuit
board system. (F-ROM)
An error occurred in the circuit
board system. (SD-RAM)
An error in heads was detected.
(Abnormal temperature was
detected.)
An error in heads was detected.
(Abnormal voltage was detected.)
An error occurred in the linear
encoder. (Counting was unable. )
An error occurred in the linear
encoder. (Error in the mounting
direction.)
An error occurred in the linear
encoder. (Read-out count error)
An error occurred in the circuit
board system.
(FPGA PDC)
An error occurred in the circuit
board system.
(FPGA PDC)
An error occurred in the circuit
board system.
(FPGA HDC)
CPU irregular interrupt has
occurred.
A program error has been alerted.
To Next Page
Loading...
