MIMAKI TS34-1800A - Setting the WIPING

3-18
Setting the WIPING
When the set number of times scanning is performed has been reached during a printing operation, a wiping
operation is performed automatically to prevent ink dew condensation on the nozzle face.
if you set the amount of ink to put more (high density, two coats, etc.), splash, ink drops or nozzle missing may
occur.
It is recommended to set the periodical wiping to maintain the comfortable drawing status at any time.
1
Press the key in LOCAL.
2
Press the key.
3
Press to select one of the types (1 to 4) and press the key.
4
Press to select [Print.CLEANING].
5
Press the key.
6
Press to select [WIPING].
7
Press the key.
8
Press the key.
9
Press to set the number of times scanning
is performed.
• Set value: 0 to 9,990 times
• The set value should be 30 to 50 times when the amount of
ejected ink is large, for example, due to two coats of ink.
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
Pr int .CLEANING <ent>
[1]Pr int .CLEANIN
CLEAN I NG <en t >
[1]Pr int .CLEANIN
ワイヒ ゜ ンク ゛ < e n t >
WI P I NG
WI P I NG <e n t >
WI P I NG
SCAN COUNT =
5 0
WI P I NG
SCAN COUNT =
4 0