MIMAKI TS34-1800A - Changing the Printing Origin

Setting a Media
2-16
Changing the printing origin
The position of the printing origin can be changed.
Moving the LED pointer to the changing position and deciding the position.
1
In Local, Press .
• It enters into the origin setting mode.
2
Set a light point of the LED pointer to the changing position by pressing
.
• Select the carriage and media, moving the point with
.
3
After determining the origin, press the key.
• The printing origin is changed.
Typical setting position of printing origin
The printing origin in the depth direction (X') is positioned at about 75 mm rearward from the slot for cutting on
the platen. The printing origin in the scanning direction (Y') is positioned at 25 mm from the right end of the
media. The value in the scanning direction (Y') can be changed using [MARGIN] in FUNCTION mode.
( P.3-3) This can be changed by using the Jog key.
• The origin position set above misaligns with the feeding direction of a media by a few centimeters.
Turn [FEED ORIGIN] “ON” in setup mode to fit the origin to the correct light position of LED pointer.
(P.3-3)
OR I G I N SETUP
0.0 ----
OR I G I N SETUP
0.0 0.0
Origin
(Length)
Origin
(Width)
OR I G I N SETUP
** ORIGIN **
slot for cutting
approx. 75 mm
(X’)
25 mm
(Y’)