3-21
1
1
3
Convenient use
5
6
Perform setting to reduce stripes between passes
In case that feeding stripes cannot be resolved even though media correction (P.3-4) is performed, make
“MAPS (Mimaki Advanced Pass System) valid. Feeding stripes become less visible by distributing the pass
boundary.
1
Press the key in LOCAL.
2
Press the key.
3
Press the key.
4
Press to select [MAPS].
5
Press the key.
6
Press to set ON/OFF.
• Set Value : OFF, ON
7
Press the key.
• When you select OFF, proceed to the Step 9.
• MAPS effect differs depending on the set value of the printing speed. Use it after checking effect in
advance.
• When you speed up the printing speed, it takes shorter time to print. However, MAPS effect becomes
weak.
• When you slow down the printing speed, it takes longer time to print. However, MAPS effect becomes
strong and feeding stripes become less visible.
• The resolutions and passes for which MAPS is enabled are shown in the following table.
• For conditions when MAPS is disabled, the printer operates with MAPS-OFF and print speed settings
disabled (±0%).
• MAPS may not be effective depending on image to be printed.
• Slight color change may be found.
Resolution
(dpi)
Pass
4 colors 6 colors
△○◎△○◎
540x360 * 1 2 4 2 4 8
540x720 2 4 8, 16 816, 32
540x1080 6 12, 24 12 24, 48
720x720 4 8, 16 816, 32
720x1080 6 12, 24 12 24, 48
720x1440 8 16, 32 16 32, 64
＊ : This printing mode can be used only when using sublimation transfer ink Sb53.
◎ : MAPS can be used when the print speed setting is within a range of ±50%, for both high speed and
standard speed.
○ : At high speed, print speed is within the range of -50% to -1%. At standard speed, MAPS can be used
when the print speed is within a range of ±50%.
△ : MAPS can be used when the print speed setting is within the range of -50% to -1% at standard speed
only.
To Next Page
Loading...
