MIMAKI TS34-1800A - If the Positions of Dots Shift

3-6
If the Positions of Dots Shift...
When the condition for printing (media thickness/ink type/etc.) has been changed, perform the following
operation to correct the ink drop position for bidirectional (Bi) printing and obtain the proper printing result.
Example of a Printed Pattern
1
Set a media on the machine and set a printing origin. ( P.2-6)
• In order to print a pattern, a media that is 500 mm wide and at least 400 mm long is necessary.
2
Press the key in LOCAL.
3
Press the key.
4
Press to select one of the types (1 to 4) and press the key.
5
Press to select [DROP POSITION].
6
Press the key.
7
Press the key to start pattern printing.
• Multiple test patterns are printed. (The printed patterns are called
Pattern 1, Pattern 2, Pattern 3... in the order of printing.)
The dots at the fourth position counted from the zero
position in the positive direction form a straight line.
In this case, the dot position correction value is 4.0.
Output
direction
FUNCT I ON
SETUP <ENT>
SETUP
SELECT : TYPE . 1
[1]
DROP POS I T I ON < e n t >
[1]DROP POSITION
PR I NT START : e n t
PR I NT I NG
PLEASE WA I T