MIMAKI TS34-1800A - Page 37

Setting a Media
2-9
1
2
Basic Operations
4
5
6
3
Move the roll holder to the roll setting position.
• Check the roll stopper is not caught between the roll stopper arm and this machine.
4
Tighten the roll holder fixing screw.
• Check the Step 2 to 3 again.
5
Set the left end of the core of the roll media on the
left roll holder.
• Push the roll media onto the roll holder until the roll core is
all the way seated.
6
Loosen the screw of the right side roll holder then
insert the holder into the core of the roll media.
7
Raise the clamp lever in the rear of this machine.
• There is the roll guide holder channel at the center of this
machine to support the roll guide so that it will not bend
even if heavy roll media is set.
• You cannot move the right side roll holder to the left side of
the roll guide holder channel.
When setting shorter media, if the right side roll holder
contacts with the roll guide holder channel, loosen the
screw at upper part of the channel and move it to the left.
At this time, move the roll guide holder channel near to the
right side roll holder.
Roll holder
Base
Roll Holder Side (The back of this machine)
Roll Holder
Set Position
3 Inch Roll Media
2 Inch Roll Media
Set the base position of roll holder
within this range.
• There are two types of the internal diameter
of the roll media paper tube: 2 inch and 3
inch.
Setting position of
2inch tube
Setting position
of 3inch tube
Roll guide holder channel
Roll guide
Right side roll holder
Clamp lever