MIMAKI UCJV300 Series - Installation Precautions; Environmental and Location Precautions

To Next Page

To Previous Page

- 15 -

When to use CuttingLink - Client?

CuttingLink - Server can register up to five plotters. As shown below, use Cutting - Client to connect more than 6

plotters.

How to set CuttingLink - Client

1. Install CuttingLink on the PC connecting 1st to 5th UCJV300/150, CJV300 Plus

series, and set it to CuttingLink - Server.( P.5 "Install CuttingLink." or later)

2. Install CuttingLink on the PC connecting the sixth UCJV300/150, CJV300 Plus series

and set it to CuttingLink - Client.

(1) Install CuttingLink on the PC to which the plotter is connected and start it.

(2) On the [Initial Setting] screen, select [CuttingLink -

Client], and then click [OK].

RasterLink

Printer - Server PC1

Printer - Server PC2

Reg

ister

Other manuals for MIMAKI UCJV300 Series